• [[ImgSrc-moreshare]]

Contact Us

Tel: 86-510-88536504

Fax: 86-510-88536521

Mob: 86-18661063329

E-mail: wdpower_young@ foxmail.com

Add: No.2721, Jiaoyang Road, Xishan district, Wuxi City, Jiangsu Province, P.R.C.

Web: http://www.wandi engine.com

Home > Knowledge > Content
Operation instruction of WD305 series diesel engine Jan 06, 2018

A. Operation for the engine

It is not allowed to operate the engine at 50% of rated power output for a long time, as it can cause high fuel consumption, valve jammed etc.

If the temperature of cooling water becomes too low, the unburned fuel may thin the oil in the oil sump, and affect lubricating efficiency.

Note: Any failures occur to parts, such as a sudden surge of oil temperature, a sudden decline of oil pressure and abnormal sounds. Please stop the engine immediately, check and repair it.

 

Before stopping the engine, run it at idling speed for 3-5 minutes, let cooling water and lubricating oil take the heat away in the engine, which is very important for turbocharged engine. Unless it is in urgent need, the engine shouldn’t be stopped suddenly; otherwise, the turbochargers will overheat and cause their bearings to seize up.

The operator should pay attention to the sounds of turbochargers to see whether any impeller knocks at the housing at the moment that the engine is stopped. If a noise of knocking is heard, please dismantle the turbocharger immediately to check the bearing clearance.

Note: Under very cold situation, exhaust all the cooling water in the engine and its accessories to protect the engine from freezing.

 

The intake and exhaust manifolds of the turbocharged engine must be free of leakage; otherwise, its performance would be lower. Check the tightness of the connecting nuts or bolts and the hose clamps frequently. If necessary, renew the sealing gasket.

Note: When customers are to select proper engine, consideration should be given to reasonable power of working machinery, as the engine shouldn’t be operated at an excessive load or very low load for a long time. Otherwise, it may lower reliability of the engine and cause some faults.

 

B. The output power for the engine

WD305 series engine outputs its power by flywheel and SAE connector which is used to drive working machinery. Belt pulley can’t be fixed to the flywheel directly, and the machine can’t be dragged in lateral direction, because they can damage the engine’s crankshaft and main bearings easily.

The maximum output power of the engine’s front extension shaft should be within 50kw, but some applications include bearings and clutch etc must be fixed to support the shaft. The power it can bear to be dragged in lateral direction must be controlled within 11kw to protect the main crankshaft and driving gears. For those engines with a fan, dragged in lateral direction is forbidden.

Note: The engine shouldn’t be started with load, therefore, a engaging and disengaging device should be fixed between the engine and those load devices can’t be operated without load, and operator should start the engine when the clutch is released.http://www.wandiengine.com/